(The host and tool can be ANY block you like, except MESH)
First, you need 2 blocks, one will be the "Host" and the
others will be a "tool" so, the host is the block you will
DEDUCT a part from with the "tool" the "tool" block will be
made a "Negate" part, do this by going to MODEL, select
the part and click "negate" Once you have done this,
use move tool to position the "tool" part into the model
where you are deducting a certain area, and select the
"tool" and the "host" (Both can be 2 parts) and press
"UNION" If something goes wrong, dont worry, press seperate
and it will go back to normal! If it says a message that
it could do it, just select it all, hold ctrl c (If windows)
and then ctrl V (On mac use CMD instead of Ctrl)
Then try Unioning it again, well dont if you read this
fare, oogabooga, bye.
-Binobag
Shoutout to
-Griffplaysthingz
-Quantz |