of     1   

Felix2231
#45761340Monday, April 18, 2011 8:15 PM GMT

How can I make meshes for the tiny parts of guns?
nicholasstormblood
#45761894Monday, April 18, 2011 8:26 PM GMT

There are no gun meshes except the ones the Admins have made in the catalog which is gear otherwise there are no ways to mesh guns. The only meshes there are the ones that are in the insert>object which there are cylinder,block, or special. But to make the tiny parts you will have to resize them to make them really small and it involves a lot of cframing if its highly detailed. That made no sense.
adark
#45762268Monday, April 18, 2011 8:33 PM GMT

@Above, incorrect. Players at one point could upload their own, custom meshes, but that was taken out for obvious reasons. What this guy is asking is detailed guns that look like meshes, but are actually multiple parts, and you were right about that: it uses the three basic meshes and sometimes the fourth mesh, which is technically part of the third. And you don't actually resize them, you make them look smaller using the Mesh's size, which is linked to the blocks size in most cases, but not with FileMeshes, the fourth type. Many gun meshes from the game Kiseki, made by Clockwork, are custom and only used there, as none of them are gear.
nicholasstormblood
#45762658Monday, April 18, 2011 8:52 PM GMT

@Above, Uh huh I understand you could upload meshes before however I was not refering to that. And also it is is resizing them because basically resizing a mesh is that same as what I said when I said "Resizing". Also most gun meshes probally were made by the old Admin"Clockwork" however gun meshes are still basically just like the ones in the catalog(some not all). So partially I will agree with you.
nicholasstormblood
#45762708Monday, April 18, 2011 8:53 PM GMT

He did not basically ask for a detailed gun that looks like meshes, he just asked on how to make the tiny parts of the gun also.

    of     1