Shivering Chairs...

Join Date: 2008-09-30
Post Count: 206

#45791706Tuesday, April 19, 2011 6:05 AM GMT

So, I made a barber shop chair and it has a hinge at the bottom so it will spin but every time I sit on it and then when I jump and when I look at it, Its always shivering like its going to blow up im afraid it might cause lag and zombies are causing lag already so how do stop it from shivering this?(I know what you going to say barber chair and zombies? its a long story)

skydude33

Join Date: 2008-06-08
Post Count: 2941

#45791740Tuesday, April 19, 2011 6:08 AM GMT

Ehhh....Do you have it anchored or is it touching a welded or glued brick?

RomerEvert

Join Date: 2008-09-30
Post Count: 206

#45791771Tuesday, April 19, 2011 6:10 AM GMT

Its un anchored so it can spin and welded to each other scriptedly but the base where the chair is connected is anchored

skipper4991

Join Date: 2010-09-01
Post Count: 1368

#45798830Tuesday, April 19, 2011 2:20 PM GMT

This is the work of the weak hinge... try making the brick that has the hinge on it larger. But don't make it too large. Just the width of the chair.

EngineerTester

Join Date: 2009-03-01
Post Count: 781

#45801579Tuesday, April 19, 2011 4:04 PM GMT

I don't think you can make a larger hinge.... Use BodyGryo or BodyPosition to prevent it from doing any movements other than rotation.

skipper4991

Join Date: 2010-09-01
Post Count: 1368

#45803027Tuesday, April 19, 2011 5:04 PM GMT

No, no. I wasn't talking about making the hinge larger, I was talking about making the brick with the hinge on it larger. This will result in greater stability.

Alex592

Join Date: 2009-10-30
Post Count: 1656

#45805143Tuesday, April 19, 2011 6:07 PM GMT

Expand the hinge. -Alex592.

skipper4991

Join Date: 2010-09-01
Post Count: 1368

#45817654Tuesday, April 19, 2011 10:17 PM GMT

That's what I said. XD